Affects
- Hacked drones flying with 4G dongle
- Issue
- 4G signal may occasionally be lost
- Solution
- Occasionally, the FCC signal may overpower the 4G dongle, causing a loss of the 4G signal. If this happens and you want to continue flying over 4G, simply disable the FCC hack with the command DH FCC off.
-----
Affects
- Hacked drones flying using FCC
- Issue
- After enabling FCC mode, the drone does not revert to CE mode even when FCC is disabled via Drone-Hacks commands. Some hardware revisions require additional steps to properly disable FCC mode. Simply using the Aircraft Name method or the Drone-Hacks v2 interface may not be sufficient
- Solution
- To successfully switch back to CE mode, follow these steps:
- Run the command
dh fcc off.
- Power off the controller.
- Restart the drone and wait for it to connect to the GPS.
- Turn the controller back on.
The drone should now be in CE mode
-----
Affects
- DJI FPV Racer with hacks applied and being used in "manual mode"
- Issue
- When flying at altitude of ~80m, manual mode will be canceled and the drone will revert to “Normal Mode”
- Solution
- None available at present. This is a firmware bug in DJI's code and not something that can currently be rectified by the Drone-Hacks team. Keep manual mode flights below a 70m ceiling height to ensure manual mode does not get disengaged.
There are no other known issues ✅ If you spot one, contact support@drone-hacks.com to report!